String Bending

String bending is a guitar technique that used usually by lead guitarists to change the pitch of a note. This guitar technique can be widely applied to a wide range of guitar styles and is most commonly found in rock music. The main reason why string bending is so widely used is because this technique gives guitar playing a more personalized and harmonic quality. Different individuals can use this guitar technique to create different textures of sounds and expressive dimensions.

Learning how to bend strings effectively is something that many guitarists find difficult. This guitar lesson will give a proper guide to help you in string bending. Let's start.....

String bending can be achieved by fretting a string and bending it either up (For 1st, 2nd and 3rd strings) or pulling it downwards (For 4th, 5th and 6th strings). Common sense would tell you that if you were to bend the 1st string downwards, the string would be pulled off the fretboard and vice versa for the 6th string. However, this is JUST a guideline. If you simply need to bend the 1st string a little and the resultant action wouldn’t make the string go off the fretboard, feel free to do pull the 1st string in a downward motion.

Standard Bend

The most common type of string bending is standard bends of either a semi or whole tone. In string bending, one of the most important things to bear in mind is the accuracy of the targeted note for bending. The easiest way to practice this is to play the pitch of the note that you are intending to bend to before performing string bending. This will help you stay in tune as the pitch is still fresh in your mind and slowly accustom your ears to bending to the correct pitch.

Download .mp3 file ( Right-click Save Target as... ) 

Pre Bend

Pre-bending simply means you fret and fully bent the note before picking the string. After the string is picked, release the string back to its original position. Instead of hearing the pitch rise, the pitch will start at its highest point and fall to the original note.

Download .mp3 file ( Right-click Save Target as... )

Smear Bend

Smear bends (aka small bends) is produced when the string is bended very slightly (approximately quarter note). This bend is very important in blues music as it creates a slightly “off” note which gives an authentic blues flavor.

Download .mp3 file ( Right-click Save Target as... ) 

Unison Bend

Unison bends is done by playing 2 different notes at the same time. While maintaining the pitch of one note, a bend is perform on the 2nd note to reach the same pitch as the 1st note. You can typically hear unison bends in Santana’s or Hendrix’s guitar playing which really adds flavor to their guitar playing.

Download .mp3 file ( Right-click Save Target as... )

String Bending Exercise 1

Download  .gtp5 or .mp3 file ( Right-click Save Target as... )

Listen to the pitch of the target note before you bend the note to the target note. This exercise will train your ears to identify the correct pitch when a note is bent.

String Bending Exercise 2

Download .gtp5or .mp3 file ( Right-click Save Target as... )

Nothing beats an exercise with a jam track to play along. Start with by learning this short solo before you inject some of your own creative ideas into the solo.

Hope you had enjoyed this guitar lesson on string bending. Now that you know how to bend strings, make sure you use this guitar technique in your playing. Have fun bending cold hard steel !